RTS KP-97 Instrukcja Obsługi Pobierz pdf (Strona 40)

7.5.3 MENUS, SERVICE, HDST MIC

For a KP-12 with an optional Rear Connector Module, you can use this item to select microphone

input from either a headset or from the EXT MIC IN connector. For all other keypanels, leave

HDST MIC set to HEADSET.

To change the setting, click on HDST MIC. Then, rotate the SELECT control to display either

HEADSET or EXTERNAL, and click again. Double-click the SELECT control to return to the

previous menu level when finished. Or, press and hold the SELECT control for about two seconds

to exit menu mode. Remember to save your changes if you want them retained for future use. See

“SERVICE MENU, SAVE CFG”, page

45.

Make sure that HDST is selected on the front panel. See “Headset / Speaker Selection and Volume

Adjustment”, page 15.

7.5.4 MENUS, SERVICE, KEY TYPE

The keypanel comes with either push-button or lever-style intercom keys. The correct key type is

factory-set and should not require change. (The correct setting is maintained even if the keypanel

is reset.)

To change the key type, click on KEY TYPE. Then rotate the SELECT control to choose either

SINGLE (push-button keys) or LEVER, and click again.

Double-click the SELECT control to return to the previous menu level. Or, press and hold the SE-

LECT control for about two seconds to exit menu mode.

Remember to save your changes if you want them retained for future use. See “SERVICE MENU,

SAVE CFG”, page

45.

7.5.5 MENUS, SERVICE, LOCK / UNLOCK

You use this item to lock or unlock menu mode. When menu mode is locked, all items in Table

(page 27) are locked out and can only be accessed by entering a 4-digit passcode.

Lock the menu as follows:

1. Select MENUS, SERVICE, LOCK. The call waiting window will display TAP CODE.

2. Enter a 4-digit passcode by tapping intercom keys. When the last digit is entered, all displays

will briefly display asterisks while the passcode is being stored, then the keypanel will reset to

the top level menu. You do not need to run SAVE CFG to store this change.

Unlock the menu as follows:

1. Select (MENUS). TAP CODE will display.

2. Enter your 4-digit passcode. When you enter the last digit, the menu will open.

3. Select SERVICE, UNLOCK. When you click on UNLOCK, all displays will briefly display

asterisks while the 4-digit passcode is being cleared, then the keypanel will reset to the top

level menu. You do not need to run SAVE CFG to store this change.

40 User Manual, DKP-8, DKP-12 and KP-12 Keypanels with Push-button Keys

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Brak uwag

RTS KP-97 Instrukcja Obsługi Strona 40