RTS RVON-I/O Instrukcja Użytkownika Pobierz pdf (Strona 28)

4. At the MXP prompt, set rvon ip_addr 10.3.210.20 (this IP Address is for example purposes only).

5. Press Enter.

An MXP prompt appears.

6. Press Enter.

The IP Address is set for the RVON-I/O.

7. Set the Netmask.

8. At the MXP prompt, type Activate.

RVON-I/O will reset itself to the new IP Address. The current telnet session becomes invalid.

Configure the RVON-I/O Using Telnet or a Serial Port

RVON-I/O programming can be done using a direct serial connect to or a Telnet connection. There are two physical

connections to an RVON-I/O:

Direct serial through a custom serial cable (connected on the back of the RVON-I/O at SERIAL)

Ethernet (Telnet Only)

Setup

Serial Port: 38,4000 baud, 8 data bits, 1 stop bit, No Parity, NO-Flow control

Telnet: IP Address, port 23

Figure 6.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Brak uwag

RTS RVON-I/O Instrukcja Użytkownika Strona 28