RTS XCP-24 Instrukcja Obsługi Pobierz pdf (Strona 29)

4-3

5 After storing the autodial number, hang up using the KP9X hang-up sequence.

Dialing an Autodial Number Stored in the TIF-951 / TIF-2000

1 Tap the PHONE key to activate dialing mode.

2 Tap "down" on the TIF talk key to latch it in the on position.

3 Tap CLR followed by the autodial number (01, 02, etc.).

4 When finished dialing, click the PHONE key again to exit dialing mode.

5 Hang up using theKP9X hang-up sequence.

DIALING AND HANGING UP USING THE KP-632 DIALING

The dialing menu will only activate when talking to an intercom port that has the "Port is TIF"

check box activated in ADAMedit. (In ADAMedit, click the "KP" button to access the

Keypanels/Ports screen, then select the port where the TIF-951 / TIF-2000 is connected, then

click the "Edit" button, then click the "Advanced" tab. Place a check mark next to "Port is TIF".

Remember to send this change to the intercom system.)

Manual Dialing

1 Turn on the TIF talk key.

ManualDial

displays in the Call waiting window.

2 Tap the PGM key.

Dial#?

displays, and the dial tone should be audible in your speaker or

headset.

Note

To hang up at any time after this point: tap the BACK key.

Hang up

will display, then tap PGM.

Note

While using the phone, any incoming intercom calls to the Call waiting window will go into the

call waiting stack. The caller names will not be displayed, but the Call waiting LED will flash red.

You may either hang up the phone and answer the intercom call, or continue with the phone call

and answer the intercom call afterward.

3 Dial the phone number. Digits appear in the Call waiting window as you dial. Dialing tones are

audible in the speaker or headset.

4 If the far end answers, begin your conversation.

Note

After the far end answers, you may dial additional digits (to retrieve voice mail, log onto an

automated answering system, etc.).

5 If there is no answer, or to hang up when finished talking, tap the BACK key.

Hang up

displays. Tap PGM to hang up.

Note

Occasionally, you may receive intercom caller names in the Call waiting window while you are

talking on the phone. In this case, the dialing menu options will be cleared from the Call waiting

window, and the

Hang up

option won't be available. Instead of trying to reenter the menu system,

use the "KP9X Keypad Hang-up Sequence".

Redial

Turn on the TIF talk key.

ManualDial

displays in the Call waiting window.

Tap the ↓↓ key until

Redial

displays.

Tap PGM.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 113 114

Komentarze do niniejszej Instrukcji

Brak uwag

RTS XCP-24 Instrukcja Obsługi Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Domofony RTS XCP-24