RTS XCP-48-RJ45 Dokumentacja Pobierz pdf (Strona 12)

12 Chapter 4 EIA-232: DB-25 to DB-25

Terminal/Printer Cable with DTR Handshaking

Note: Some terminal or printer manufacturers may use different methods of

flow control. Consult your documentation for specific wiring

requirements.

DB-25 Hardware Handshaking (RTS/CTS) Cable

The following cable is often sufficient for a terminal, printer, or other DTE

device configured for RTS/CTS (hardware) flow control. However, some

terminals and printers may have other cable requirements. Consult your

terminal or printer manual for this information. For more universal

compatibility, use a fully-wired DB-25 terminal/printer cable.

Terminal/Printer Cable with RTS/CTS Handshaking

Note: Some terminal or printer manufacturers may use different methods of

flow control. Consult your documentation for specific wiring

requirements.

DB-25 Female

(Digi End)

DB-25 Male

(Peripheral)

Signal Pin Pin Signal

TxD 2 connected to 3 RxD

RxD 3 connected to 2 TxD

CTS 5 connected to 20 DTR

SG 7 connected to 7 SG

GND Shell connected (via shield) to Shell GND

jumpered 4+5 RTS+CTS

DB-25 Female

(Digi End)

DB-25 Male

(Peripheral)

Signal Pin Pin Signal

TxD 2 connected to 3 RxD

RxD 3 connected to 2 TxD

RTS 4 connected to 5 CTS

CTS 5 connected to 4 RTS

DSR+DCD 6+8 connected to 20 DTR

SG 7 connected to 7 SG

DTR 20 connected to 6+8 DSR+DCD

GND Shell connected (via shield) to Shell GND

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 151 152

Brak uwag

RTS XCP-48-RJ45 Dokumentacja Strona 12