RTS XCP-48-RJ45 Dokumentacja Pobierz pdf (Strona 23)

Chapter 6 EIA-232: RJ-45 to DB-25 23

Part numbers for RJ-45 to RJ-45 8 pin Crossover Cable for Cisco & Sun Netra:

RJ-11 Software Handshaking (XON/XOFF) Cable

The following 3-wire cable is often sufficient for a terminal, printer or other

DTE device configured for software flow control.

Simple Software Handshaking Terminal/Printer Cable (RJ-11)

This cable is a 3-wire null modem cable. Transmitted Data on one end of

the cable is connected to Received Data at the other end and vice versa.

The RJ-11 plug fits into the center of the RJ-45 jack. The male DB-25 end

can be plugged directly into most serial terminals and printers without any

adapters.

An RJ-45 8 pin connector uses the same wiring with the center pins only-

pins 3, 4, 5, and 6. See the section titled RJ Connector Types for a

comparison of various RJ connector types that work with the Digi 10 pin

RJ-45 jack.

RJ-45 8 pin Plug Hardware Handshaking (DTR) Cable

Using an 8 pin plug, the following cable wiring is often sufficient for a

terminal, printer, or other DTE device configured for DTR (hardware) flow

control. However, some terminals and printers may use a signal other than

DTR for flow control. In addition, some terminals and printers may have

other cable requirements. Consult your terminal or printer manual for this

information. For more universal compatibility, use the RJ-45 10-wire

terminal/printer cable or a Digi RJ-45 to DB-25 adapter.

Cable Description Order #

Number

found on

Cable

Cable RJ45 to RJ45 8 pin (single pack) 76000631 63000222-02

Cable RJ45 to RJ45 8 pin (bulk pack of 8) 76000632 63000222-02

Cable RJ45 to RJ45 8 pin (bulk pack of 16) 76000633 63000222-02

RJ-11

(Digi End)

DB-25 Male (Peripheral)

Signal Pin Pin Signal

TxD 2 connected to 3 RxD

RxD 3 connected to 2 TxD

SG 4 connected to 7 SG

GND 1 connected (via shield) to 1 (or shell) GND

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 151 152

Brak uwag

RTS XCP-48-RJ45 Dokumentacja Strona 23