RTS KP-12 Instrukcja Użytkownika Pobierz pdf (Strona 25)

Bosch Security Systems, Inc.

User Manual

F.01U.193.243

Rev. 11

CHAPTER 4

Telephone Operation

NOTE: KP-12 and DKP-12 Only, Requires optional TIF Interface. These products do not connect to the public telephone

network directly.

If the intercom system is equipped with an optional TIF telephone interface, one or more intercom keys on the KP-12 keypanel

may be assigned for use as phone keys. There are three types of phone key assignments:

All-purpose phone key (usually identified as TEL1, TEL2, etc.): may be used for manual dialing, for last number redial, and

for auto-dialing any of ten stored phone numbers.

Redial Key (RDL): redials the last number when activated.

Autodial Key (ADL0-ADL9): dials one (1) of 10 previously saved autodial numbers when activated.

The following paragraphs describe how to use each of these three (3) types of phone keys.

All-Purpose Phone Key Operation

The following paragraphs assume that a phone key has already been set up and is ready for use. If a phone key has not been set

up, see “Menus, KEY ASGN, PHONE (For KP-12, DKP-12 Only)” on page 40.

Names for general purpose phone keys are assigned, like any other intercom port name, using the intercom system

configuration software. Suggested names are TEL1, TEL2, etc. to distinguish phone keys from other types of intercom keys.

Manual Dialing with an All-Purpose Phone Key

1. Tap the phone key to begin your call.

This places the keypanel in dial mode: the CALL indicator turns on, and MAN DIAL (manual dial) displays in the call

waiting window. You hear the dial tone.

NOTE: You can hang up the phone line at this time by tapping the phone key again.

2. Tap the SELECT control to select MAN DIAL.

The 12 intercom keys can now be used to dial a telephone number. Each key corresponds to the number printed next

to it on the front panel. If the KP-12 has alphanumeric displays, the key numbers are displayed above each key.

3. Begin dialing the number by tapping the appropriate keys.

After you dial the first digit, END DIAL displays in the call waiting window. When you have completed dialing, tap

the SELECT control to select END DIAL. This returns the KP-12 to normal operating mode. If the called party

answers, proceed with you conversation as for any other intercom call. To end the phone call, hang up as described

below.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Brak uwag

RTS KP-12 Instrukcja Użytkownika Strona 25