RTS KP95 Instrukcja Użytkownika Pobierz pdf (Strona 83)

Advant Controller 31 / Issued: 03.99

5 Hardware 07 KP 95 R101

8 .6

1.5.2 Connection of the supply voltage 24 V DC

As shown in Fig. 3 and Fig. 4, the supply voltage for the

07 KP 95 is looped through from the AC31 basic unit (red

wire = L+, blue wire = M).

1.5.3 Networking interface

The networking interface, a special parallel interface, al-

lows the 07 KP 95 communication processor to be con-

nected to AC31 basic units 07 KT 93 and 07 KT 94. The

housing of the communication processor is connected to

the housing of the ABB Procontic basic unit by a snap-fit

connection. The electrical connection is via a 40-pole rib-

bon cable with socket connector, soldered onto the

07 KP 95 R101 side.

Note: Attachment and disconnection of units on the net-

working interface may only be performed when all supply

voltages are switched off.

Mounting the communication processor at the net-

working interface

1. Detach the cover on the basic unit (e.g. 07 KT 94)

from the networking interface.

2. Plug the socket strip of the 40-pole ribbon cable se-

cured to the 07 KP 95 R101 onto the networking con-

nector of the AC31 basic unit.

3. Slide both units together.

4. Slide the replacement cover provided with the 07 KP 95

unit with its cut-out onto the networking interface.

1.5.4 Measures for RFI

(Radio Frequency Interference)

– Installation in a metallic switch-gear cabinet

– Mains filters

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89 90

Brak uwag

RTS KP95 Instrukcja Użytkownika Strona 83